
Installation of flipper or pocket doors is a snap for builders and manufacturers with this set of slides. Designed to be used with a wood follower strip fabricated by the user, these will accomadate practically any sized door. One set of two slides is normally required for each door, but a 3rd slide may be used on exra large or heavy doors. All 3 may be attached to the same follower.
The door must be attached to the follower by a hinge which must be purchased separately by or furnished by the builder. The typical application calls for a 110 degree, 00 crank, full overlay Euro hinge to be used in faceframeless cabinet. The recommended hinge would be L-H71023-NP-A and plate would be L-H71006-NP-A. However, these may not work for every application, and builder should make this determination themselves.
This is a set of 2 slides (enough for one door). A typical installation will require 2 sets.
Technical Specifications
Mounting: Side mounted to the cabinet side panel.
Hinge is mounted in wooden follower strip.
Features: Designed to use wooden follower strip,
3rd slide is mountable to the cabinet for heavier
door support.
Height: Minimum 1/16” between door and cabinet
Clearance: 1/2” plus 1/32” minus 0” each side
Loading Rate: 20 pound class
Finish: Zinc plated ( ZP )
Sizes: 14”, 18”, 16”, 20”
Size - - -Part # - - - - - - - Slide - -Travel
in/mm - - - - - - - - - - - - - mm - - -mm
20/500--- L-D77020 ---505.0---417.4
18/450--- L-D77018 ---454.2---366.6
16/400--- L-D77016 ---403.4---312.5
14/350--- L-D77014 ---352.6---265.0
Installation instructions and screws not included. This is not a consumer pack item.
|