Product Overview
Attention: Please see the 2nd and 3rd photos. This run of the hinges will not complete 90 degrees. They get caught at about 80 degrees. We are selling them this way as there are still useful applications. We will get the proper ones in stock as soon as possible once we determine the issue.
Flap Hinge Antique Copper
Also known as a Drop Flap Hinge
This is a must have hinge for the construction of drop-front panels and anywhere a flush mount hinge is needed to stop at 180 degrees so surfaces are flush with each other
Closed position is 90 degrees
Mount this hinge by boring a 1-3/16 inch hole 1/2 inch deep using a Fostener bit or a router. Bore a 1-3/16 inch x 1/8 inch place for the flap side.
This hinge is most commonly seen on computer desks with a drop-down drawer front where the keyboard drawer pulls out
Installation of this hinge is not an amateur job
- Flap Centers: 7/8 inch two holes and 5/8 inch middle hole to side hole
- Flap Dimensions 1-3/16 inch x 7/8 inch
- Total Dimensions: 1-7/8 inch open width overall
- Base Dimensions 1-3/16 inch x 1/2 inch
- Finish: Antique Copper
NO screws furnished-requires 6 -#4 or #5 X 5/8 inch screws
PLEASE NOTE: This hinge is designed to fit in a fostener drilled flat bottom recess 1-3/16 inch Diameter for a tight fit in 3/4 inch wood thickness. A longer screw will not work unless your wood is thicker. If you will notice, the screws go in at an angle and not straight through. The design behind this is that when the hinge is slipped into the recess(which must be a pretty tight fit) then the screws go in at an angle and hold it in place by a wedging effect. This allows it to be secured and still remain usable in a 3/4 inch board. It is difficult to install so we do mention that it inch is not an an amateur job inch D. Lawless Hardware
